Pace-edwards PowerGate LK170 Dodge Ram 1500 (2009-2010) Manual de usuario

Busca en linea o descarga Manual de usuario para Para El Coche Pace-edwards PowerGate LK170 Dodge Ram 1500 (2009-2010). Pace-Edwards PowerGate LK170 Dodge Ram 1500 (2009-2010) User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 2
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
INSTALLATION INSTRUCTIONS
LK 170
STEP 1 : INSTALL POWERGATE
!! NOTE: BE SURE TO PROTECT ALL PAINTED SURFACES OF THE TRUCK !!
With the tailgate open, remove the screws from the tailgate access panel using a #10 Torx driver. Remove the two (8mm)
nuts that hold the handle assembly. Install PowerGate™ lock through the tailgate opening and over the studs of the handle
assembly. Replace 8mm nuts and tighten. Slide lock bolt with your ngers to see that there is no interference and that the
bolt locks the handle. Adjust if necessary.
STEP 2 : ROUTE WIRE HARNESS & RELAY LOOM WIRES
Route the short wire harness through the drain hole in the bottom of tailgate and connect it to PowerGate. Plug the long wire
harness to the short wire harness. Route the long wire harness underneath the driver’s side of the truck to the rewall.
Using the Relay Loom on the drivers side of the engine compartment thread the purple and gray wire loom through the re
wall of the truck. (Try to follow OEM wire routes whenever possible.)
TOOLS REQUIRED:
#10 Torx bit 8mm Socket 6” extension or nut driver is helpful
PACKAGE CONTENTS:
SHORT WIRE
HARNESS
LONG WIRE
HARNESS
WIRE TIES
POWERGATE
ACTUATOR
WIRE T-TAPS
WIRE RELAY
HARNESS
STEP 3 : LOCATE & CONNECT WIRES
2009 RAM 1500
Locate the TAN/ GREEN and TAN/ WHITE wires on the driver’s side under the dash by the brake pedal. The wires are
in the bigger of the 3 harnesses.
Install one blue wiretap on each of the two wires indicated above. Plug the purple and gray wires to the wire taps. Return
to the engine compartment and plug the long wire harness from the PowerGate unit to the Relay loom with the green and
blue wires. (Testing will be done later to insure appropriate connections) (continued on next page...)
2009 DODGE RAM 1500
Vista de pagina 0
1 2

Indice de contenidos

Pagina 1 - INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONSLK 170STEP 1 : INSTALL POWERGATE!! NOTE: BE SURE TO PROTECT ALL PAINTED SURFACES OF THE TRUCK !!With the tailgate open, remo

Pagina 2 - STEP 4 : SECURE WIRES

STEP 4 : SECURE WIRESInstall tailgate access panel. Secure all wires with wire ties provided so that there are no loose, dangling ends.STEP 3 : LOCATE

Comentarios a estos manuales

Sin comentarios